Racepak Dash CAN Setup

This section describes how to connect an Racepak IQ3 dash to the Emtron CAN bus.

Racepak Device Compatibility

250-ds-Iq3s - Street display

250-ds-iq3d - Drag logger

250-ds-iq3ld - Logger dash

250-ds-iq3sl - Street logger

250-ds-iq3 – Display only

These devices require an interfacing module to talk to additional ECU systems/components

** Requires Universal EFI Module 230-vm-efiucan

Racepak CAN Wiring colors

• Green = ground
• Black = CAN Lo
• White = CAN Hi

ECU Setup

• Select either CAN1 or CAN2
• Select a Channel with CAN1 or CAN2
• Set Enable to ON
• Set CAN Address = 1250
• Select required DATA Set; Predefined or custom
• Set Direction to transmit
• Set Addressing to sequential
• Set required Transmit Rate. CAUTION. Do NOT set to high as this will limit the available bandwidth to other devices on the bus

Racepak Setup

A default RacePak Config file has be created to match the Emtron ECU Predefined1 DATA set. This is called Emtron_Predefined1_IQ3_Config.rcg. This should be programmed into the ECU.