Idle PID Setup

Control Rate

The rate at which the PID control algorithm calculations are performed.

Typical : 10 Hz

Idle Deadband +/-

The output control signal is held constant when the Input Signal (RPM) falls within the deadband range of the Setpoint (Idle Target). This helps reduce steady state error and oscillations.

Typical : 20 RPM

RPM Filter

Filters the RPM signal to allow better PID control

Typical : 5

Integral Positive/Negative Clamp

Allows the user to set the minimum and maximum I gain compensation used by the closed loop system.  

Re-entry Delay

Delay once all lockouts are cleared before Closed Loop Idle Control becomes active.

** Will immediately become active if engine speed falls below the Target RPM