Timers

Timers

The following calculated runtimes are generated by Emtron that are Timer related (to be further discussed more specifically):

  • User Timers - Status of User Timers
  • Crank Exit Timer - Time counter after cranking
  • Crank Timer - Time count during cranking
  • Firing Events Counter - Count of engine firing events
  • Engine Cycle Counter - Count of engine cycles
  • Engine Runtime - Engine runtime
  • ECU Runtime - ECU on runtime
  • TPS WOT Timer - Time throttle position is wide open
  • TPS Closed Timer - Time throttle position is closed
  • MAP High Timer - Time manifold pressure is high
  • Gear Cut Timer - Gear cut duration
  • Pedal Closed Timer - Time pedal position is closed
  • Race Timer - Race timer
  • Gearshift Cut Start - Gearshift time from cut start
  • Gearshift Next Gear - Gearshift time to next gear
  • Upshift Measured - Measured upshift time
  • Downshift Measured - Measured downshift time
  • Anti-Lag Disarm - Disarm timer for Anti-Lag

Many of these timers are pre-configured and function automatically.

User Timers

Timers must be enabled Config > Function Setup > Timer Functions

User Timer Setup

Timers are configured in the Tuning section

Tuning > Timer Functions Configuring timer 1-5 opens up a configuration window to set conditions, max time, and Timer Reset Mode

Set the conditions for the timer to start using Emtron ECU runtimes or status. There are up to 4 conditions that can be used to start the timer.

Image Image

Max Time

Set the max time the timer can count

Timer Reset Mode

Image Image

Reset when Timer Function turns OFF

The timer will reset when the conditions are no longer met

Example:

Timer condition is >3000 rpm, the timer will reset every time the engine speed falls below 3000rpm.

Reset when Timer Function turns ON

The timer will reset when the conditions are met again

Example:

Timer condition is >3000 rpm, the timer will reset when the engine speed falls below 3000rpm, and then goes past it again

Never

The timer will not reset

Fixed Timer Setup

Fixed Timers are configured in the Tuning section

  • Tuning, Timer Functions, Fixed Timer Setup

Image Image

TP1 WOT Timer ON

Set what position TP1 needs to surpass to start counting TP WOT time

TP1 Closed Timer ON

Set what position TP1 needs to be below to start counting TP Closed time

MAP High Timer ON

Set what kPa MAP needs to surpass to start counting MAP High time

PP1 Closed Timer (pp1)

Set what position PP1 needs to be below to start counting PP Closed time

PP1 Closed Timer (rpm)

Set what RPM needs to be below to start counting PP Closed time

Race Timer Start Mode

Select from the following to trigger the Race Timer to start or create a custom function using a User Output

Image Image

Race Timer Max Time

Max time for Race Timer

Race Timer Reset Mode

Select from the following to trigger the Race Timer to reset or create a custom function using a User Output

Image Image