Emtron Lambda to CAN (ELC/ELCM) Setup

For details : 

Emtron Lambda CAN Manual

Click the link below to download or visit Emtron www Downloads

ELC

Reset CAN IDs to Default

0: OFF

1: ON

This will reset the ELC CAN IDs back to their default values

Channel 1 = 671, Channel 2 = 672

Set back to zero when finished.

Enable Heater Override 

0: OFF

1: ON

When enabled, the ECU controls when the Lambda heater is ON or OFF. This is done through  the “ELC HEater RPM Lockout” and “ELC Heater Post Start Lockout: settings. 

When disable the ELC controls the heater(s) which will turn On 15 secs after the device power up.

Enable EMAP 

0: OFF

1: ON

When enabled, the ECU will send EMAP data to the ELC. This units should be in kPa

** When enabled please make sure the EMAP is configured correctly inside the ECU.

ELC Heater RPM Lockout 

RPM Below which heater will be locked out

ELC Heater Post Start Lockout 

Timer before which heater will turned on Post Start up

ELC Lambda 1 Test Enable 

Forces the ELC to send this Test Value over the CAN bus.

Allows the user to confirm the ECU calibration is setup correctly.

0 = OFF

ELC Lambda 2 Test Enable 

Forces the ELC to send this Test Value over the CAN bus.

Allows the user to confirm the ECU calibration is setup correctly.

0 = OFF