Racepak Dash CAN Setup

This section describes how to connect an Racepak IQ3 dash to the Emtron CAN bus.

Racepak Device Compatibility 

250-ds-Iq3s     - Street display

250-ds-iq3d     - Drag logger 

250-ds-iq3ld     - Logger dash 

250-ds-iq3sl     - Street logger

250-ds-iq3     – Display only 

These devices require an interfacing module to talk to additional ECU systems/components

** Requires Universal EFI Module 230-vm-efiucan

Racepak CAN Wiring colors

• Green  = ground
• Black  = CAN Lo
• White = CAN Hi

ECU Setup

• Select either CAN1 or CAN2
• Select a Channel with CAN1 or CAN2
• Set Enable to ON
• Set CAN Address = 1250
• Select required DATA Set;  Predefined or custom
• Set Direction to transmit
• Set Addressing to sequential
• Set required Transmit Rate. CAUTION. Do NOT set to high as this will limit the available bandwidth to other devices on the bus

Racepak Setup

A default RacePak Config file has be created to match the Emtron  ECU Predefined1 DATA set. This is called Emtron_Predefined1_IQ3_Config.rcg. This should be programmed into the ECU.